hanging idle 300 xc w

Just about anything, but remember it's family.

hanging idle 300 xc w

Postby oldschoolktm » Mon Aug 12, 2019 5:30 pm

Jetting issues?
Thought to post and get some feedback.
Running a 165mj, 35 pilot, third clip.
Once the bike warms up and after a WOT run I come to a stop and she wants to keep going. I mean it sounds like an air leak but I have sprayed carb cleaner on the boot and no change in idle.
My throttle cable is stock and running a 2" bar riser but this did not happen last year with the same set up.
Possible reed wear? Have yet to check.
Power valve was cleaned while doing the top end this winter.
FMF Gnarley with stock silencer.
No exhaust leak at the head pipe.
Carb cleaned with ultrasonic cleaner.

Please do not tell me to go and buy a lectron!

Your experience appreciated!
Thanks in advance!
Chris
KTM 525 exc, KTM 300xc w
oldschoolktm
Hardcore Contributor
 
Posts: 134
Joined: Tue Jun 11, 2013 6:33 pm
Location: Stittsville
enthusiast: Yes
Skill testing question: 2435

Re: hanging idle 300 xc w

Postby geastman » Mon Aug 12, 2019 8:11 pm

I don't think worn reeds give that symptom.

Could still be an air leak, at crank seal. I seized my old Husky 125/144 when the ignition side seal went....

If that's not it, you could always try a Lectron :P

pistons.png
pistons.png (882.55 KiB) Viewed 117 times
geastman
Pro Contributor
 
Posts: 76
Joined: Sun Aug 06, 2006 10:51 am
enthusiast: No
Skill testing question: 2435

Re: hanging idle 300 xc w

Postby FJ11 » Fri Aug 23, 2019 7:35 am

Hi Chris,

IMO a hanging idle after hard run would indicate a lean condition on the pilot circuit.
Where is the air screw (AS) set to now? how many turns out is it?

I would try turning it in by 1/4 turn to richen it slightly and see if that helps.

Mark
Mark
2012 300 XCW
FJ11
Intermediate Contributor
 
Posts: 27
Joined: Thu Jun 04, 2009 9:18 pm
enthusiast: Yes
Skill testing question: 2435

Re: hanging idle 300 xc w

Postby Lc82 » Sat Aug 24, 2019 8:28 pm

My 2013 300 Xcw had fueling issues and it ended up being float adjustment . Maybe something to check.
Lc82
Intermediate Contributor
 
Posts: 25
Joined: Fri Sep 01, 2017 7:59 pm
enthusiast: Yes
Skill testing question: 2435


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 5 guests

cron